Pump installation, starting, running, stopping 1. Installation sequence (1). The base on the foundation, the anchor bolts at the horn, the horn will be used to adjust the wedge in between the method of correcting level, and tighten the bolt appropriate 350S-75 double suction pump, to prevent walk. (2) between the base and the foot pump pouring of concrete. (3) After the concrete dries tighten the bolt and re-check the level of the pump. (4) the concentricity of the motor shaft and the pump calibration. (5) Check the motor rotation coincides with the pump after the turn, mounted on the coupling of the coupling pin. (6) pipeline pumps out extra bracket support should not be supported by the pump. II. Pump installation position of the pump mounting position should be properly double-suction pump, and as close to the liquid source delivery 350S-75A double suction pump, ensure that there is adequate space for operation, maintenance, disassembly and inspection of the pump. Pump mounting height does not consider the pump cavitation. The main pumping station should seriously consider: pumping stations should have enough capacity lifting equipment and auxiliary equipment, when the pump motor is driven 350S-75B double suction pump, should consider the environmental impact of the equipment, the room should be ventilated to prevent excessive heat wet. Double suction pump | 350S-125 double suction pump | Impeller (certified merchants) provided by the Shijiazhuang-Pump Co., Ltd. faction. Shijiazhuang-school Pump Co., Ltd. (www.shipaipump.com) is specialized in "slurry pumps, submersible pumps, sewage pumps, chemical pump, pulp pump, water pump, mud pump, multi-stage" of the enterprise, the company of " honesty, hard service "concept, to provide you with the highest quality products and services. Welcome to inquire! Contact: Manager Xu.