Shijiazhuang-school Pump Co., Ltd. to provide you with IS water centrifugal pump - Shijiazhuang-faction pump. Shijiazhuang-school Pump Co., Ltd. (www.15130676788.com) is located in Shijiazhuang Shiqiao Western, No. 186 Friendship Street, Contact: Manager Xu wiring: nameplate requirements must correct wiring, the wiring, the terminal must be firm, not allowed IS65-40-315B loose water pump, water pump or IS65-40-315A will cause poor contact caused by burn-in phase. To ensure reliable operation of motors, electrical switches should be fitted with overload protection device at pipeline pump IS65-40-315 water pump, and adjust the size of the set value of the protection device in accordance with the current requirements of the motor nameplate. 4, the axial IS centrifugal water pump seal ring is packing gland, packing rings and packing, etc., in order to prevent water leakage into the air or a lot. IS pump impeller, if the balance is equipped with wadding impeller inlet port communicating with the cavity, impeller inlet of liquid in a vacuum, it is very easy along the sleeve surface of the intake, so the packing cavity equipped with a packing ring By pump cover holes, the pump chamber pressure water lead to the packing ring seal. If not pump impeller balance holes, due to the back of the impeller fluid pressure greater than atmospheric pressure, so there is no leakage problems, it is time to install packing rings. 5, IS centrifugal water pump shaft to avoid wear on the shaft through the packing chamber parts fitted sleeve protection. There are O-ring seal between the quasi sleeve and the shaft, to prevent mating surfaces along the inlet or leaking. 6, IS centrifugal water pump drive way is by lengthening the flexible coupling and motor coupled to the rotation direction of the pump from the drive end IS, clockwise rotation. 7, IS centrifugal water pump in order to balance the axial force of the pump, before most of the pump impeller, a sealing ring after all, and the cover plate is provided in the impeller balance holes, because some of the shaft is not to force, the back of the impeller seal ring and balance holes are not provided. IS | water pump | IS65-40-315B Clean Water Pump Co., Ltd. provided by the Shijiazhuang-send pump. IS | water pump | IS65-40-315B Clean water pump sent Shijiazhuang-Pump Co., Ltd. (www.shipaipump.com) this year introduced a new upgrade, the above picture is for reference only, please call the contact or pictures on this page phone, for the latest information, Contact: Manager Xu.